SNMP v3 and Cacti
A quick synopsis on setting up a Cisco ASA and a Centos 6 or 7 system to use SNMP v3 to be monitored by Cacti Cisco ASA en conf t # create a snmp-server group (needed for SNMP v3) # … Continue reading →
Category Archives: SNMP
Juniper SRX Routing Engine Temperature OID and Nagios
jnxOperatingTemp.9.1.0.0 or 1.3.6.1.4.1.2636.3.1.13.1.7.9.1.0.0 Settings for Nagios to monitor temperature on SRX using snmp v3 /usr/lib64/nagios/plugins/check_snmp -H 10.254.253.1 -o 1.3.6.1.4.1.2636.3.1.13.1.7.9.1.0.0 -w 43 -c 45 -u C -P 3 -L authPriv -U SNMPUSERNAME -a MD5 -A AUTHPASS -x aes -X PRIVPASS SNMP … Continue reading →
Monitor CPU and GPU Temperature and undervoltage of a Raspberry PI via CLI, SNMP and Cacti
The following is a primer for setting up your Raspberry PI to use SNMP to monitor the CPU and the GPU temperature in Cacti and to monitor the undervoltage condition. The instructions below cover Raspbian 11. I am assuming you … Continue reading →
Juniper SNMP Settings
SNMP V1 and V2c set snmp location “Text String That Indicates Where This Is At” set snmp contact “usually@MyEmail.com” set snmp community MyCommunityString authorization read-only set snmp community MyCommunityString clients ip.addresses.allowed.access/24 set snmp community MyCommunityString clients moreip.addresses.allowed.access/24 SNMP V3 set … Continue reading →
refused smux peer: oid SNMPv2-SMI::enterprises.674.10892.1, descr Systems Management SNMP MIB Plug-in Manager
I had the following entry appear in the messages file every few seconds refused smux peer: oid SNMPv2-SMI::enterprises.674.10892.1, descr Systems Management SNMP MIB Plug-in Manager Based on my research, I found someone who said: More than likely a Dell … Continue reading →